Emtech-electronics BLU-CIF Manuel d'utilisateur télécharger pdf (Page 6)

“+” (pin 3), and the “-“ (pin 2) to the “-“ (pin 4), when output port 5 on the

DSP is triggered. This is typically used to switch speaker level signals, so

an overflow room can be fed directly from an amplifier without needing its

own dedicated amplifier channel.

Connecting the BLU-CIF to the BSS Audio London Series DSP

The BLU-CIF ships with two pre-fabricated 12-conductor cables. Each

cable has 3.5mm connectors on both ends. On one end, the 3.5mm

connectors are color-coded green and black, so they match up with either the

Control Port 1 (Black) connector or Logic Inputs (Green) connector on the

upper right quadrant of the CIF Board.

Control Inputs Connector

Logic Outputs Connector

Control Inputs connector mates with the cable

with Control_Port1 (Black) connector.

Logic Outputs connector mates with the cable

with Logic Inputs (Green) connector.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Emtech-electronics BLU-CIF Manuel d'utilisateur Page 6